The codes that apply to marinas
- NFPA 303, Fire Protection Standard for Marinas and Boatyards: fire protection, fueling, and electrical safety on docks. Your state or local fire marshal enforces the edition adopted in your area.
- NFPA 70 (National Electrical Code), Article 555: wiring and shore power on docks, including ground-fault protection to limit current leaking into the water. Stray current in the water causes electric shock drowning, so pedestal and wiring checks are a safety job, not only an electrical one.
- EPA's SPCC rule (40 CFR part 112), if your aboveground oil storage at the fuel dock and yard is more than 1,320 gallons. Underground fuel tanks fall under the UST rules in 40 CFR part 280 instead.
- OSHA's forklift rule (29 CFR 1910.178) for dry stack forklifts, including an examination before each day's use.
A good maintenance schedule for a marina
- Daily in season: walk the docks for loose boards, trip hazards, missing life rings and lights out; check the fuel dock spill kit and the area around the dispensers.
- Monthly and after storms: full dock inspection with the checklist below, including pilings, float chains, cleats and gangways.
- Monthly: shore power pedestals, cords and receptacles; fire extinguishers on the docks and fuel dock.
- Before and during the season: boat lift cables, sheaves, gearboxes and motors, with grease points done before launch.
- Yearly: electrical inspection of dock wiring and ground-fault protection by a licensed electrician; fire extinguisher service; tank inspections your SPCC plan lists.
- By engine hours: travel lift and forklift oil and hydraulic service, at the maker's intervals.
How to set it up
- Walk the marina and list every dock section, gangway, pedestal, lift, fuel dispenser and machine.
- Give each one a short ID that matches a tag or label on site, such as Dock B, pedestal 12.
- Assign each check a frequency and a person, and put storm checks on the list so they happen the morning after.
- Record each inspection and repair with the date, who did it and what was found.
Records worth keeping
Keep dock inspections, electrical work, fuel dock checks and lift service in one place. Your insurer, the fire marshal and the electrical inspector will ask for them, and after an incident on a dock, a dated record of inspections and repairs is the best evidence you have.
Marina dock and safety inspection
Monthly and after storms
Docks and gangways
- Decking secure, no loose or broken boards
- Cleats tight and not cracked
- Pilings and float chains sound
- Gangway hinges and rollers working
- Ladders secure and reaching the water
Shore power
- Pedestal ground-fault test passes
- Receptacles not cracked, no heat marks
- Shore power cords not frayed or in the water
- Pedestal doors and covers closed
Fuel dock
- Hoses, nozzles and breakaways in good condition
- Emergency fuel shutoff marked and working
- Spill kit and absorbent booms stocked
- No smoking signs posted
Safety equipment
- Life rings in place with line attached
- Fire extinguishers charged, tag current
- Dock lights working
- Emergency signs and phone numbers posted
Inspected by, date and notes go at the bottom of the printed sheet.
Run it in Dovient Lite
Add each dock section, pedestal, lift and the fuel dock as assets and print QR labels for the pedestals and lifts. Set a monthly schedule with this checklist attached and hour-based schedules for the travel lift and forklift; a work order opens when each is due. Dock hands mark each item on the phone with a photo, staff report problems from the phone with a photo and the report becomes a work order, and every repair and part used stays on that asset's record.
Start with Dovient LiteSources
- NFPA 303, Fire Protection Standard for Marinas and Boatyards
- NFPA 70, National Electrical Code, Article 555
- EPA, Oil pollution prevention (SPCC rule), 40 CFR part 112
- OSHA, Powered industrial trucks, 29 CFR 1910.178
Rules change and vary by state and county. Check the current text with your inspector or authority having jurisdiction. Last reviewed 2026-11-15.
Questions
- How do I set up a marina maintenance and safety checklist?
- List every dock, pedestal, lift and the fuel dock, give each a frequency and a person, and add a storm check. Record every inspection and repair with the date and who did it.
- What's a good maintenance schedule for a marina?
- Daily walks in season, a full dock and pedestal inspection monthly and after storms, lift service before the season, and a yearly electrical inspection by a licensed electrician.
- Which codes cover marina electrical safety?
- NFPA 70 Article 555 covers wiring and shore power on docks, and NFPA 303 covers fire and electrical safety at marinas. Your local authority enforces the editions it has adopted.
- Does a marina fuel dock need an SPCC plan?
- Only if your aboveground oil storage capacity is more than 1,320 gallons and a spill could reach the water. Underground tanks fall under the UST rules instead.