Set up each lift as its own record
List every lift with its slip number, maker, model, rated capacity, drive type (cable winch, hydraulic or vertical), and the boat it carries. Rated capacity matters: a lift loaded beyond it, or a boat that has been re-powered and gained weight, wears cables and gearboxes fast. Note the install date and when the cables were last replaced.
Boat lift maintenance schedule
Replace cables at the first sign of broken strands, and on the schedule the lift maker sets. In salt water expect a shorter life than in fresh water. Use the manufacturer's intervals for gearbox oil and grease.
- Each use or weekly in season: lift runs smoothly, no grinding, boat sits level on the bunks, cables wind evenly on the drum.
- Monthly in season: cables for broken strands, kinks, rust and flattening; pulleys and sheaves turn freely; bunks and pads secure; fasteners tight; motor and gearbox no leaks; GFCI or ground-fault device tested.
- Every season or year: grease bearings and fittings with marine grease, change or top up gearbox oil, check hydraulic fluid and hoses, inspect the frame, welds and pilings for corrosion and damage, and test limit switches.
- After a storm or high water: full inspection before the lift is used.
Boat lift electrical requirements
Lift motors and the dock power that feeds them are covered by Article 555 of the National Electrical Code (NFPA 70), as adopted in your state, which requires ground-fault protection for marina and dock power. Electrical work on lifts and docks should be done by a licensed electrician, and new or changed circuits need a permit and inspection from your local authority.
Staff should test the ground-fault devices on the schedule your electrician or the device maker sets, and look for damaged cords, loose conduit and burnt or corroded connections.
What to record
- Each inspection: date, lift, items checked, cable condition, who did it.
- Each repair: what failed, parts used, cost, and how long the lift was out of service.
- Cable and motor replacements, with the date, so you can plan the next one.
Run it in Dovient Lite
Add each boat lift as an asset with its slip as the location, and print a QR label for the lift's post. Set a monthly in-season schedule with an inspection checklist and a yearly schedule for greasing and gearbox service, so a work order opens when each is due. Dock hands mark each item pass, warning or fail on the phone with photos, and cables and parts used come off stock and add to that lift's cost.
Start with Dovient LiteSources
Rules change and vary by state and county. Check the current text with your inspector or authority having jurisdiction. Last reviewed 2026-11-15.
Questions
- How often should a boat lift be inspected?
- A quick check at each use or weekly in season, a full inspection monthly, and greasing, gearbox and structural service once a year. Inspect again after any storm.
- How often should boat lift cables be replaced?
- At the first sign of broken strands, kinks or heavy rust, and on the lift maker's schedule. Salt water shortens cable life.
- What grease should I use on a boat lift?
- A water-resistant marine grease, or the type the lift maker lists. Grease bearings and fittings at least once a season.
- What is a good maintenance schedule for a marina?
- Monthly dock and pedestal walks, monthly fuel dock and extinguisher checks, in-season lift inspections, and yearly service of lifts, pumps and electrical equipment.