Dovient

How-to

Turf & mower equipment maintenance (reel grinding, PMs)

How to set up turf and mower equipment maintenance on a golf course: daily checks, reel grinding and backlapping, service by engine hours, and what to record for each machine.

Start with the fleet list

List every machine with its make, model, serial number and hour meter: greens mowers, tee and approach mowers, fairway and rough units, sprayers, topdressers, aerators, utility vehicles and the grinder itself. Group them by what they cut so the reel work can be planned. The hour meter is the key number, because almost every manufacturer sets service by engine hours, not by date.

A practical lawn equipment maintenance schedule

These ranges are typical; your operator's manual is the rule for each machine.

  • Before each use: engine oil and coolant level, hydraulic leaks, tire pressure, height of cut, reel to bedknife contact (paper test), safety interlocks and seat switch.
  • After each use: wash or blow off clippings, check for damage, grease points the manual lists as daily.
  • Every 50 to 100 hours: grease all points, check belts, air filter and battery. Use the intervals in your operator's manual.
  • Every 100 to 250 hours, or yearly: engine oil and filter, fuel filter, hydraulic oil and filter on the interval the manufacturer sets.
  • Off season: full teardown of cutting units, bearings, rollers and bedknives, and calibration of sprayers.

Reel grinding and backlapping

A sharp reel cuts the leaf cleanly; a dull one tears it and leaves a frayed, discolored surface. Most courses backlap between grinds to keep the edge, and spin grind the reel and face the bedknife when backlapping no longer restores the cut or after the reel hits something hard.

Base grinding frequency on quality of cut and hours, not on the calendar. Greens units usually need it most often, rough units least. Record each grind and backlap on the cutting unit with the hours, the person, and whether the bedknife was replaced, so you can see which units wear fastest.

What to record

  • Each service: date, hour meter reading, what was done, parts and fluids used, who did it.
  • Each grind or backlap: cutting unit, date, hours, bedknife replaced or faced.
  • Each repair: what failed, how long the machine was down, parts and labor cost.

Run it in Dovient Lite

Add each mower, sprayer and utility vehicle as an asset and set preventive maintenance schedules by hour meter readings, with a checklist for each service, so a work order opens when the machine reaches its hours. Date schedules cover the off-season teardown and sprayer calibration. Parts and fluids used on a work order come off stock and add to the machine's cost, and the dashboard shows downtime, MTTR and MTBF for the fleet.

Start with Dovient Lite

Questions

What is a good maintenance schedule for golf course equipment?
Daily pre-use checks and cleaning, greasing every 50 to 100 hours, and oil, filter and hydraulic service on the manufacturer's hour intervals. Do major cutting unit work in the off season.
How often should reels be ground?
When backlapping no longer restores a clean cut, or after the reel strikes something. Greens mowers need it most often. Track grinds by hours to find your own interval.
Should mower service be scheduled by hours or by date?
By hours for engines, hydraulics and cutting units, because that is how manufacturers set it. Use dates for seasonal jobs such as teardowns and calibration.
What should a lawn equipment maintenance log include?
Date, hour meter reading, work done, parts and fluids used, and who did it, kept for each machine.